A switch is a switch, and an LED is an LED, but this LED illuminated button is a lovely combination of both! It's a medium sized button, large enough to press easily but not too big that it gets in the way of your project panel. It has a built in LED that can be controlled separately from the switch action - either to indicate or just to look good.
The body is a black plastic with the LED built inside. There are two contacts for the button and two contacts for the LED, one marked + and one -. The forward voltage of the LED is about 2.2V so connect a 220 to 1000 ohm resistor in series just as you would with any other LED to your 3V or higher power supply.
This particular button has a green body and LED and is latching on/off. The two switch contacts are either connected or disconnected. When you push the button they will switch from one to the other, like an on-off switch. The LED is separated from the button, so you can make it light up when on, light up when off, always lit, etc.
16mm Illuminated Pushbuttons (7:54)
Ya esta disponible la nueva Arduino UNO R4 con mejores características Arduino UNO R4 con Wifi y la versión sin wifi Arduino ...
Integra todas las funciones de la Arduino Duemilanove en tamaño reducido.
Ideal para protoboard ...
El ADXL355 de Analog Devices es un acelerómetro de tres ejes con muy bajo ruido y un consumo de corriente de solo 320uA. Puede medir el rango de +/-3g. Alimentación de 1.8 a ...
Al aplicarle una fuerza varía la resistencia. Admite carga entre 100g y 10kg Dimensiones: Longitud total: 2.375" Ancho total: 0.75" Diamétro sensible: ...
Este sensor permite medir la humedad del suelo con lo que se puede detectar cuando hay que regar las plantas. Incluye ...
Potencia máx: 90mW Tensión máx: 150 Vdc Temperatura: -25 a 75ºC Resistencia 10 lux: >50K ohms Resistencia 0 lux: >0.9M ohms El C-2795, fotorresistencia LDR, disminuye su resistencia en proporción al aumento de la ...
Ideal para Arduino ya que funciona con 5V. Voltaje de control 5V Valores Máximos: 10A 250VAC, 10A ...